Description:
Elos OsmoController
Digital Water Level Controller
OsmoController Digital
The entirely new OSMOCONTROLLER Digital uses a patent pending sensor
with no moving parts as the first measure of the water level in the
SUMP. Most other systems will use multiple float switches or sensors to
act as back up to the initial float switch, elos does not. We believe
the float switch or sensor will always be the weak link as it is usually
a moving part and/or in direct contact with the water, most of the
time.
To provide an adequate fail-safe the OSMOCONTROLLER Digital
uses a small microprocessor in combination with our patent pending
sensor to control the pump and monitor the top off of your system. In
the event of a fault such as an empty reservoir, a damaged pump or
kinked tube, the microprocessor will recognize this and a red alarm LED
will indicate the problem and stop pumping until the problem is fixed
and the controller can be reset. The OSMOCONTROLLER Digital also has a
manual top off button that can be used to use the system as a pump for
occasional water changes and to fill a container with RO/DI water
easily.
The set up of the OSMOCONTROLLER Digital is very simple. It works with
most sumps without the need for programming and with our sensor design
has a built in buffer for waves and small changes in the sump that will
normally cause a top off system to unnecessarily top off, which will
shorten the useable life of the top off pump.
Key Benefits of the OSMOCONTROLLER Digital:
* No moving parts
* Very easy setup. (System runs a 5 minutes self-diagnostic test when it is first plugged in.)
* Maintains a very accurate level, very important in marine systems for a stable salinity level when keeping delicate animals.
* Adapts to most aquarium/sump sizes automatically.
* Requires 3/8" tubing, which is not included